Tavor X95 5.56 NATO 18.5″ Barrel & Bolt Kit

This kit can only be used to replace an existing 18.5″ (non-restricted state) Tavor X95 barrel. This barrel does not contain a barrel band and must be used with the non-barrel band cocking rod.

This 18.5″ barrel bolt kit comes headspaced from the factory and should be used together. Be sure to replace your bolt when replacing your barrel. Please check your local and state laws before assembling your Tavor X95 with your new barrel & bolt kit.

Included:

• Tavor X95 5.56 NATO 18.5″ barrel – cold hammer forged, CrMoV, chrome lined, 1:7″ twist
• A2 flash suppressor
• Tavor 5.56 NATO right or left hand bolt
• Tavor barrel wrench

Please follow the following steps in your Tavor X95 manual (Rev 00) in order to install your barrel & bolt kit:

Section 14.1.2 Sear Mechanism

Section 14.1.3 Recoil Mechanism

Section 14.1.5 Foregrip Assembly

Section 14.1.6 Cocking Bar Assembly

Section 14.1.7 Barrel-Rail Group

Section 14.2.1.1 Gas-operated Recoil Mechanism

Section 14.2.2 Barrel-Rail Group

Removing your barrel without completing the above sections first will damage your barrel.

Warning: You must use the new barrel with the provided bolt to ensure headspacing is correct. Failure to do so may result in a catastrophic failure of your barrel and/or bolt and cause destruction of property, personal injury and/or death to you or bystanders.

If you are using the P/N: 08011021600 Rev.: C or D Tavor® X95 manual please follow the following steps in order to install your barrel & bolt kit:

Section 14.1.3 Sear Mechanism

Section 14.1.4 Recoil Mechanism

Section 14.1.6 Foregrip Group

Section 14.1.7 Cocking Bar Assembly

Section 14.1.8 Barrel-Rail Group

Section 14.2.1.1 Gas-operated Recoil Mechanism

Section 14.2.2 Barrel-Rail Group

Removing your barrel without completing the above sections first will damage your barrel.